Cisco 400-201 Exam Dumps For Success

Skills to design, implement, diagnose, and troubleshoot complex Service Provider services are tested in CCIE Service Provider Certification written exam. Cisco 400-201 dumps contain authentic knowledge which enhances your skills to answer the necessary questions of the written exam.

Try it Latest DumpsSchool 400-201 Exam dumps. Buy Full File here: https://www.dumpsschool.com/400-201-exam-dumps.html (699 As Dumps)

Download the DumpsSchool 400-201 braindumps from Google Drive: https://drive.google.com/file/d/1keAzpsvJwLMJ1MmaK28b34t3vZ9J1NnN/view (FREE VERSION!!!)

Question No. 1

Refer to the exhibit

Refer to the exhibit. AS2000 has deployed the BGP additional path feature. Assuming GP filtering has been deployed in any routers, how many entries does R1 have in the RIB/FFIB table for the 18.47.3.0/24 prefix?

Answer: B

Question No. 2

Which two steps take place in the BGP Link State architecture? (Choose two)

Answer: A, B

Question No. 3

In the context of GMPLS, LMP stands for:

Answer: D

The Generalized Multi-Protocol Label Switching (GMPLS)[1] is a protocol suite extending MPLS to manage further classes of interfaces and switching technologies other than packet interfaces and switching, such as time division multiplex, layer-2 switch, wavelength switch and fiber-switch.

GMPLS is composed of three main protocols:

Resource Reservation Protocol with Traffic Engineering extensions (RSVP-TE) signaling protocol.[5][6]Open Shortest Path First with Traffic Engineering extensions (OSPF-TE) routing protocol.[7][8] Link Management Protocol (LMP).[9]

Question No. 4

Refer to the exhibit

Refer to the exhibit. CE6 cannot ping the loopback address of C7.An SP engineer notices a routing loop between PE2 and CE4. Which configuration must be applied on both PE routers to avoid the routing loop?

Answer: A

Question No. 5

Which two statements are correct?

Answer: C, D

VC Type 4 is used for Ethernet VLAN mode.

VC Type 5 is used for Ethernet Port mode.

Question No. 6

MPLS label mapping on an LSR is displayed by which IOS command?

Answer: B

Question No. 7

Two router that run LotherDP have multiple links that connect them to each. Which configuration ensure that the label bindings are not flushed from the LIB if one of the links fails?

Answer: A

Question No. 8

In a L2VPN service, customer CE sends frames to PE1 using a CoS making value of 3. However , the remote CE receives those frames from PE2 with a CoS marking value of 0. Which description of this behavior is true?

Answer: D

Question No. 9

In the MC-LAG environment, which two statements about clustering HA are true?

Answer: A, B

Question No. 10

A network engineer needs to connect two core switches that use Gigabit Ethernet interfaces in an MPLS backbone and that are separated by a distance of 60 km. Which Cisco GBIC achieves this goal?

Answer: D

Question No. 11

Two MPLS VPN customers want to acquire Internet access. They make use of overlapping address space but do not want to use NAT on the CPEs. Which action satisfies this requirement?

Answer: A, B

Question No. 12

A network engineer wants to leak only IPv6 loopback addresses from level 2 to level 1. All of the other level 2 prefixes should not be advertised into level 1. Which technique will achieve this goal, based on IOS SRE release?

Answer: C

Question No. 13

Which statement about LDP Session Protection and LDP-IGP sync is true?

Answer: D

Question No. 14

Which feature allows an MPLS TE tunnel to be used by an IGP at the headend of the tunnel ?

Answer: E

Question No. 15

Refer to the exhibit.

An MPLS VPN service has been provisioned for an ABC customer. Based on the output from the VRF BGP configuration of PE1 and PE2, which statement describes the route exchange between ABC site 1 and site 2?

Answer: A

400-201 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1keAzpsvJwLMJ1MmaK28b34t3vZ9J1NnN/view

Exam Vendor: Cisco dumps

         

Facebook Comments